Operation

You have the result in just 2 minutes.

Operation of the ZFG Light Weight Deflectometer is convenient and simple, as attention was already paid during design and development to automatically ruling out incorrect measurement by means of an internal plausibility check. This ensures that even a non-specialist can operate the tester correctly and obtain precise measurement results after a brief introduction.

The measurement procedure depicted below shows the simple and quick performance of the measurement that can be immediately printed out on site with the integrated mini printer and stored on the SD card for later printouts at the PC.

1. Position load plate
1. Position load plate
2. Switch on tester
2. Switch on tester
3. Measurement
3. Measurement
4. Result
4. Result

1. Step

Place the loading plate on the soil to be tested with full contact surface and place the Loading device on the loading plate.

2. Step

Connect mechanics and electronics with the measuring cable. Switch the device on.

3. Step

Carry out 3 pre-loading impacts, start the measurement process and then carry out 3 measurement impacts.

4. Step

The measurement is complete. All data is saved, can be printed out and transmitted to the PC.

ZFG 3000 GPS

1. Position load plate
2. Switch on tester
3. Measurement
4. Result

1. Step

Place the loading plate on the soil to be tested with full contact surface and place the Loading device on the loading plate.

2. Step

Connect mechanics and electronics with the measuring cable. Switch the device on.

3. Step

Carry out 3 pre-loading impacts, start the measurement process and then carry out 3 measurement impacts.

4. Step

The measurement is complete. All data is saved, can be printed out and transmitted to the PC.